This Falcon Board Is Being A Pain
Posted 13 February 2012 - 05:31 PM
Should I remove the cpu heatsink and try using the other cpu pll bypass point or have I caused some damage when I bridged that point to the resister right above it?
Posted 14 February 2012 - 10:53 PM
Posted 14 February 2012 - 11:26 PM
I removed all the wires and chip and it works fine, with a wire going to that cpu pll there is no boot.
Nothing is touching so I don't know, tested with a voltmeter.
Posted 15 February 2012 - 02:23 PM
Posted 16 February 2012 - 01:34 AM
Posted 24 February 2012 - 12:06 AM
sounds like he hasnt even read the nand and flashed the .ecc file.
Correct, I did not read or flash the nand but I did flash the chip.
The biggest issue is that if anything is soldered to that point the xbox will not boot.
Posted 24 February 2012 - 12:51 AM
Posted 24 February 2012 - 01:37 AM
Man do you know that rgh will not boot a stock dashboard.
I believe I have never had an issue booting stock with the chip on..
But the problem here and I'm not sure if anyone knows I just have a wire going to that point not touching anything or connecting back to the chip and the console will not boot until that wire is removed.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users