Jump to content


Guide Button Led Mod, Button Not Sticking Down After Pressed

  • Please log in to reply
2 replies to this topic

#1 AdamP2006


    X-S Member

  • Members
  • Pip
  • 86 posts
  • Xbox Version:unk
  • 360 version:unknown

Posted 19 February 2012 - 03:30 PM

So i finally got round to trying the guide button led mod, and i'm using a single 5mm led and wiring so that its only on when the controller is (using resistor and transistor) , but when the guide button is pressed it doesn't return, i'm guessing because now the plastic is gone and its just hot glue in there it can't push it back up, is there anyway around this ? or any trick to getting it working without this issue in future (i can always get another guide button off evilbay or something...

#2 sinclairuser


    X-S Senior Member

  • Members
  • PipPip
  • 171 posts
  • Xbox Version:v1.6
  • 360 version:v3.0 (falcon)

Posted 19 February 2012 - 05:00 PM

its too short or its sticking is the rubber pad seated correctly

#3 dopesun


    X-S Senior Member

  • Members
  • PipPip
  • 221 posts
  • Location:BKNY, NEW YORK CITY
  • Xbox Version:none
  • 360 version:v5.0 (360S - trinity)

Posted 28 February 2012 - 09:12 PM

Check that the hot glue isn't on the sides of the guide button. That will also cause it to stick. Ask me how i know...?

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users