Jump to content


Photo

Leaving Nand Programmer Hooked Up


  • Please log in to reply
4 replies to this topic

#1 nymous

nymous

    X-S Enthusiast

  • Members
  • 2 posts

Posted 22 February 2012 - 05:05 PM

Hi, noob here...

I need to wire up my USB NAND programmer to the XBOX360 motherboard so that I could reprogram the NAND.

Question is, after the job is done, may I leave it there wired up for future reprogramming? Or do I have to disconnect it and reconnect it every time I intend to reprogram the NAND?

Thanks!

#2 Aldanga

Aldanga

    X-S Hacker

  • Head Moderators
  • PipPipPipPipPipPip
  • 2,722 posts
  • Gender:Male
  • Interests:Hardware,software,coding,algorithms, troubleshooting, tinkering with anything I can get my hands on.
  • Xbox Version:none
  • 360 version:v5.0 (360S - trinity)

Posted 22 February 2012 - 08:49 PM

You can leave it hooked up. It should not cause any harm.

#3 BoNg420

BoNg420

    X-S Messiah

  • Head Moderators
  • PipPipPipPipPipPipPip
  • 3,803 posts
  • Gender:Male
  • Location:USA
  • Xbox Version:none
  • 360 version:v5.0 (360S - trinity)

Posted 22 February 2012 - 08:51 PM

Some people just dremel the side of their case under the hard drive to make easy access.

Some people have used CAT5 cable and used the connectors. Then they just wire the one connector to the board so when they hook up their programmer, it just snaps into the connector. Of course you just have to make sure your wires match the points on the motherboard as they do on the programmer.

#4 jery911

jery911

    X-S Young Member

  • Members
  • Pip
  • 40 posts
  • Xbox Version:none
  • 360 version:v5.0 (360S - trinity)

Posted 22 February 2012 - 11:55 PM

yes it fine, just make sure you dont short out anything when putting the disc drive back on

#5 nymous

nymous

    X-S Enthusiast

  • Members
  • 2 posts

Posted 23 February 2012 - 02:26 AM

Thanks for all of the replies, guys. I guess I'll go ahead and just leave the programmer inside, of course carefully insulated and affixed.





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users