Leaving Nand Programmer Hooked Up
Posted 22 February 2012 - 05:05 PM
I need to wire up my USB NAND programmer to the XBOX360 motherboard so that I could reprogram the NAND.
Question is, after the job is done, may I leave it there wired up for future reprogramming? Or do I have to disconnect it and reconnect it every time I intend to reprogram the NAND?
Posted 22 February 2012 - 08:49 PM
Posted 22 February 2012 - 08:51 PM
Some people have used CAT5 cable and used the connectors. Then they just wire the one connector to the board so when they hook up their programmer, it just snaps into the connector. Of course you just have to make sure your wires match the points on the motherboard as they do on the programmer.
Posted 22 February 2012 - 11:55 PM
Posted 23 February 2012 - 02:26 AM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users