Jump to content


Photo

Using An Existing Switch To Power Off Led's?


  • Please log in to reply
1 reply to this topic

#1 SOLDIER1stClass

SOLDIER1stClass

    X-S Enthusiast

  • Members
  • 4 posts

Posted 30 March 2012 - 05:08 AM

I want to light up my ABXY buttons, I have a CG2 board and I need to use a way to power off these LED's after I turn off the controller.

Right now I have a cheap rapid fire kit installed on my controller, it has a button to power on/off/change modes which is wired to the bottom right SMD LED on the ROL

I'm curious if its possible to also use this button to power the ABXY LED's on/off?

here is a picture I took from the rapid fire kits tutorial (I marked in yellow where the chip is wired to the current ROL led)

IPB Image

sorry if I've left anything out or made it confusing, I'm new to modding and electronics in general

any help would be appreciated

#2 SOLDIER1stClass

SOLDIER1stClass

    X-S Enthusiast

  • Members
  • 4 posts

Posted 01 April 2012 - 09:41 AM

Nvm this thread, I figured it out!




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users