Jump to content


Photo

Jasper 512mb Convert To 16mb Nand


  • Please log in to reply
1 reply to this topic

#1 sas83

sas83

    X-S Young Member

  • Members
  • Pip
  • 50 posts

Posted 17 April 2012 - 04:14 PM

I have jasper 512Mb with burned nand(i have full dump of that nand,did it previously)...need to replace burned nand on 16Mb nand(coz have only that chip)...how to convert 512Mb dump to 16Mb? or maybe someone know how to do ECC from 512Mb dump for 16Mb nand?

Edited by sas83, 17 April 2012 - 04:35 PM.


#2 Antman1

Antman1

    X-S Freak

  • Members
  • PipPipPipPipPip
  • 1,227 posts
  • Xbox Version:v1.0
  • 360 version:v3.0 (falcon)

Posted 17 April 2012 - 05:56 PM

is it a JTAG or RGH Console?

You would have to change the resistors like the pic below:
IPB Image
This is a pic from the XD Card mod guide written by "mastag21"

And you would need to extract the KV from your BB Nand backup then create your new nand image using 360multibuild or Jtool depending on whicheverone you want to use.
problem is going to be if you have the CPU key or not. If you dont you will need to load Xell first to get it. if it is a JTAG then no problem just flash the Xell.bin file over and boot it up. if it is a RGH then you will need a donor Jasper 16mb image and then make the ecc file to flash over. then flash the ecc file over and run the reset glitch hack to load xell.

It can be done just will take some playing with it. Also you will need to know the LDV value from the nand backup you had on BB nand. you may even be able to create the ECC file directly from the BB nand to flash to the 16mb tsop. keep us informed. I always wanted to play with a conversion like this.

Edited by Antman1, 17 April 2012 - 06:19 PM.





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users