Jump to content


Photo

Rgh2 On Stinger Using Tx Files?


  • Please log in to reply
3 replies to this topic

#1 sowa99

sowa99

    X-S Senior Member

  • Members
  • PipPip
  • 184 posts
  • Location:Poland
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 04 May 2012 - 05:51 PM

Hi.
I'm wondering if xsfv from team xecuter would work on maximus stinger. Anyone know?

If someone has coolrunner and would be able to check where points on chip are connected, maybe we could figure it out to boot it on stinger smile.gif

So, if somebody could trace coolrunner, I will measure my stinger smile.gif

Regards

btw. I don't know why topic was moved here, it's about modchip research, not about onboard kernel smile.gif

Edited by sowa99, 04 May 2012 - 05:56 PM.


#2 sowa99

sowa99

    X-S Senior Member

  • Members
  • PipPip
  • 184 posts
  • Location:Poland
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 04 May 2012 - 07:21 PM

Okay, here we go with maximus stinger:


Stinger Pad ------- Xecuter pad ------ XILINX Stinger ------- Xilinx Xecuter

Slim/phat select ------ Switch ----- 13 ---------- x

D(I2CSDA)---F----25---x
E(i2cSCL)---E---24----x
C(STBYCLK)---B--35--x
P30(POST)--C--5--x
p40(CRESET)--D--13--x

There is PPL BYPASS too but it's not used in RGH2.
If someone will look at coolrunner please, check where C15 is connected! smile.gif

Here is xc2c64a pinout:
IPB Image

Edited by sowa99, 04 May 2012 - 07:29 PM.


#3 iglitare

iglitare

    X-S Senior Member

  • Members
  • PipPip
  • 178 posts

Posted 05 May 2012 - 03:47 PM

c15 is betweeen CPU_RST and GND.
But only in Phat mode and only at a TX coolrunner.
Stinger has these 3 optional caps, as long as you dont select them, you should have the same result like a TX coolrunner withoud c15.

BTW.
LED will not work, because its wired at a different port on the stinger

#4 sowa99

sowa99

    X-S Senior Member

  • Members
  • PipPip
  • 184 posts
  • Location:Poland
  • Xbox Version:v1.0
  • 360 version:v1 (xenon)

Posted 05 May 2012 - 06:18 PM

so if I will use rgh2 xsfv file from executer at stinger, this should work, right? So these chips are pin to pin compatible?

regards

Edited by sowa99, 05 May 2012 - 06:19 PM.





0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users