Custom Xbox 360 Slim Vault Case
Posted 28 May 2012 - 01:21 PM
Sanded back the holes with the dremel, helps with the filler something to adhere to
The stand is slightly raised up because of the rubber pads underneath. Just enough of a gap to install some LED's inside the feet for a glowing stand. These should be powered by a USB port so no need to open your Xbox for a power source, I want this case to be able to be attached to anyone's Xbox 360 Console.
Filler over the holes, will sand back and then apply another thin layer. As always less is more, you do not want to be sanding filler all day.
Base in primer, the small holes / indents above each foot, I will fill these as it does not fit with the rest of the design.
Posted 29 May 2012 - 03:50 AM
Paint it green, stick a head on it and call it a creeper.
Posted 29 May 2012 - 01:51 PM
Ran out of primer
Filled out these small indents
Posted 17 June 2012 - 12:36 PM
Posted 29 June 2012 - 01:06 PM
Base / Stand
First Light Coat on the Side
New paint I have been using. Australian based company but made in China. Great coverage, huge range of colours but some of the most toxic paint I have ever used. I have stopped because I can't find a mask around the house ill have to wait till tomorrow to continue.
Posted 01 July 2012 - 01:55 PM
Matching controller for the case, ill try and blend the camo pattern with the holder
I use 3M tape, don't bother with the cheap stuff honestly worth spending the extra money
Lighter color over the top
I have no patience, I always take the tape off early
Base coat on the other side
Posted 08 July 2012 - 03:46 AM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users