Is it better to update the NAND on other NAND(S) first by flashing through xell or is it better to physically hook up a programmer to do it.
I am questioning this because I did the update through xell on a triple nand system after raising the LDV on my RGH image and it was fine and booted, but then I went to try the retail dash it raised the LDV before I updated that side and wouldn't boot and I had to dick around for awhile messing with different images until I got the retail side updated right.
Why did the LDV raise when I flashed the image in Xell for the RGH NAND? Is it because of the way I flashed it or is it because I tested out that dash before updating the retail? Also I notice there are 2 places you can change the LDV value, which one is the correct one to raise?
Thanks for any help provided on clearing this up.
Edited by BoNg420, 07 June 2012 - 03:55 AM.