Jump to content


Photo

Need Help With Old Benq Vad6038


  • Please log in to reply
3 replies to this topic

#1 thund3rstruck

thund3rstruck

    X-S Member

  • Members
  • Pip
  • 144 posts
  • Location:ORF
  • Xbox Version:v1.6
  • 360 version:v2 (zephyr)

Posted 09 June 2012 - 09:33 PM

Hi everyone,

I flash my LiteOn all the time with no troubles but I've got this old BenQ drive that I just can't seem to get to work. It's an old BenQ VAD6038-64930C from 2008 and it has never been on the Internet and never been flashed.

I loaded JungleFlasher and read the original firmware (saving it to disk along with the key.bin). JF asked to autoload LTPlus 1.1 and I agreed. I wrote the firmware and sent the outro. From that point forward it lights up like a Christmas tree with 3 red rings.

I've tried restoring the original firmware from the OFW bin JF created but no luck. I tried to flash back to stock (though I'm not 100% sure which stock firmware to use; I tried all 4 that matched my model information).

At this point not sure what to do. Red ring no matter what I flash onto the drive....

Any help is greatly appreciated.



#2 thund3rstruck

thund3rstruck

    X-S Member

  • Members
  • Pip
  • 144 posts
  • Location:ORF
  • Xbox Version:v1.6
  • 360 version:v2 (zephyr)

Posted 09 June 2012 - 11:45 PM

I did the RRoD diagnostic test and the error code is 0110, Memory Fault / Memory Overheat Fault. So this doesn't seem to be related to the act of flashing the drive, it must be a coincidence.

#3 hardie

hardie

    X-S Freak

  • Members
  • PipPipPipPipPip
  • 1,048 posts
  • Location: Australia
  • Xbox Version:none
  • 360 version:v1 (xenon)

Posted 11 June 2012 - 12:34 AM

sure you dont have a faulty hard drive
does it get red rings without the hard drive attached

#4 xboxdawg

xboxdawg

    X-S X-perience

  • Members
  • PipPip
  • 367 posts

Posted 13 June 2012 - 08:21 PM

Sounds like an unfortunate coincidence...




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users