Jump to content


Photo

Jungle Flasher: No Drive Detected After Erase


  • Please log in to reply
2 replies to this topic

#1 killians31

killians31

    X-S Enthusiast

  • Members
  • 16 posts

Posted 11 August 2012 - 04:38 AM

Hey guys,

I have had my 360 on LT 3.0+ for a couple months now, and was in the process of reverting the firmware back to stock to perform an XBL update, but ran into a little bit of an issue here.

I hooked up everything to my desktop, opened up jungle flasher, loaded my original dummy.bin & stock firmware 74850C, spoofed the drive and executed the erase lite-on job.

All was going well, but it appears i was a little slow power cycling the drive. I re-ran the job and the drive seemed to be in 'vendor-mode', however i was unable to write the stock firmware to the drive.

When i re-started the jungle flasher application, im getting 'No drive detected', im also unable to eject my drive.

I really hope i didn't totally fuck the drive on this.

Please help!

Thanks,
Ben

#2 iateshaggy

iateshaggy

    X-S Hacker

  • Members
  • PipPipPipPipPipPip
  • 2,514 posts
  • Xbox Version:v1.6
  • 360 version:v4.0 (jasper)

Posted 11 August 2012 - 05:05 AM

select the right port, hit intro, turn drive on. it is not going to be detected, its blank.

#3 xboxdawg

xboxdawg

    X-S X-perience

  • Members
  • PipPip
  • 367 posts

Posted 13 August 2012 - 07:22 PM

If that doesn't work, you may have to do the LO-ERAS procedure.

THere is a thread on that. It's stickied at the top.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users