Frag After Duox2 Gs Install
Posted 15 August 2012 - 05:46 AM
When I power on with button, the chip will blink red each time the xbox will start,shut off like three times then frag red/grn. If I power on with the eject button it boots to MS dash.
If I grd the DO wire from board it frags. If I disconnect the DO the chip flashes a steady red (normal) no matter which button I press.
Any help greatly appreciated thank you
Posted 21 August 2012 - 02:27 PM
Posted 21 August 2012 - 06:01 PM
Posted 04 January 2013 - 06:51 AM
This is in 2006. Picture is kind of blurry. I had a shitty camera then.\
The hardest part of it all is holding the LPC header pins on the other side. lol. with a 40watt iron at 700 degrees is not fun. It need to be that hot to do a LPC rebuild. Because the pins act as a heat sink. The trick was to get hot and fast and get outta there. If you linger there too long. You risk ripping off a LPC ring.
Edited by deilzfcjk, 04 January 2013 - 07:01 AM.
Posted 04 January 2013 - 05:10 PM
Just push the lpc header "well the pins, still connected to the plastiic" through some electrical tape.
tape it to the top side so the legs pop through the lpc.
but i would reccomend a wire rebuild.
Posted 05 January 2013 - 06:37 AM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users