Jump to content


Photo

Is There A Guide For Reflashing Without Modding?


  • Please log in to reply
2 replies to this topic

#1 Shotokan5150

Shotokan5150

    X-S Enthusiast

  • Members
  • 5 posts

Posted 02 September 2012 - 08:59 PM

I gotta replace a liteon drive for a friend the laser took a shit in the old drive but I can still read it get keys dump files ect ect. I ordered him a new drive and need to flash the drive so it will work with his 360 and also needs to work on live. I am not modding I just want to write a clean and safe image back to his NEW drive that will work for him like new. How should I go about this is there a writeup anywhere on this? I was also considering just swaping the boards on the drives and it should just work without rewrite correct? Whats my best route to take here?

Thanks in advance.

#2 Aldanga

Aldanga

    X-S Hacker

  • Head Moderators
  • PipPipPipPipPipPip
  • 2,722 posts
  • Gender:Male
  • Interests:Hardware,software,coding,algorithms, troubleshooting, tinkering with anything I can get my hands on.
  • Xbox Version:none
  • 360 version:v5.0 (360S - trinity)

Posted 02 September 2012 - 09:35 PM

Swapping the boards would likely be the easier solution if the laser is what's bad. I would have recommended just replacing the laser as it's much cheaper and easier, but since you've already bought the drive, swapping the PCB is likely the way to go.

#3 RhoTrux64

RhoTrux64

    X-S Enthusiast

  • Members
  • 1 posts

Posted 04 September 2012 - 08:32 AM

Flashing the key to the new drive is the same process as modding. With the right tools that could be done in five minutes. Swapping the PCB will require soldering (I'm sure you were already aware). Not my forte. Laser replacement would have been cheapest route.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users