Jump to content


Photo

I Stripped Metal Inside A Point. Please Help!


  • Please log in to reply
1 reply to this topic

#1 Optikill

Optikill

    X-S Enthusiast

  • Members
  • 1 posts

Posted 30 August 2003 - 05:32 AM

I have a 1.0 motherboard and was trying to clean the solder from the holes thoroughly and ended up stripping all of the metal inside one LPC point. Meaning, I can't fill the hole with solder and the trace on top ends at the edge of the hole attached to nothing. Is it possible to fix this in some fashion?
Thanks

#2 winnieandbuzz

winnieandbuzz

    X-S Member

  • Members
  • Pip
  • 69 posts

Posted 30 August 2003 - 07:34 AM

you might want to try putting in a very thin thread all the way through and solder this on both sides of the PCB (only when on both sides is a solderpoint. If it is at one side of the board you could scrape of some lacquer of the trace and solder it to that. BUT: this is very delicate so you use good materials and equipment. It is possible!




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users