ATTN V1.1 users of the MatriX


During the installation of the chip in Mode 1
the Led should flash Green for a split second
while you power up the console and then it
will flash Red.

This is only for the V1.1 installation and do
not let the Red flashing confuse you.

After you get the split second of flashing Green
switch to the mode you want to use and reboot
the console to boot from your chip.

The easiest way to test for correct alignment is
to very carefully watch the led while powering up
If you see a flash of green then the alignment is
correct. If you see no green at all then you should
try realigning.

You may try to fill in the holes with v1.1 boxes since
most of them come without solder int he points where the
pins connect to. Just apply a small amount of solder
in the holes to make sure the pins are making contact
Also remember to clean the 9 LPC points and the Gspot
with alcohol when you are done.

Hasn't this been said here about 100000 times?

Indeed. This has been known for months.

there are many posts that people have problem with the alignment.

yes those are the people that don't know the search button