TO THE MODS , PIN this guide , it's working 100% and i think a lot of guys are waiting for this !!!
Ok this is what i did , i had flashed my tsop with a bad bios , the result was : No AV signal and the dvd tray would not eject anymore.
This is what i did to fix it (took me 4 days to get it right):
First my configuration:
with this chip:
Make sure the 2 points on top of the motherboard are soldered OK.
Connect D0 (otherwise chameleon won't boot) AND A15 !!!
if you don't know where to connect them to , get this :http://images.xodus-chip.com/Pinheader_Install.zip
and take a look at fig 3b
I set my chameleon to Mode 1 , this means 4x256kb .
Boot your chameleon with a bank , wich contains a valid bios (example mine had in bank 0 , the xectuter 2 4977 )
Flash another bank of your chameleon with the d6 tsop bios , it's included in the latest evolution-X dashboard 1.8.3921.
If you don't know what to add to your evox.ini , so you can flash the seperate banks in evox dash , take a look here :http://forums.xbox-scene.com/index.php?act...ST&f=51&t=61755
So in my case i flashed the d6 tsop bios in bank 3 .
Now you have to set the dip switches to that bank , so the chameleon boots the d6 tsop bios.
In my case ; to boot from bank 3 i had to set dip1 and 2 OFF and dip 3 and 4 ON.
So now my chameleon boots the d6 tsop bios.
I used the 007+raincoat trick now. What the d6 tsop bios does , is when you use it on your chameleon, it automatically uses the A15 to flash you tsop , instead of the chameleon.
Raincoat detected my WINBOND - W49F020 (256k) , erased whole chip and flashed it with X2 v4977
and it worked !!!!
it took me 4 days , but now my tsop is recovered !
Conlcusion : CHAMELEON OWNZ !!!!!!!
P.S. : special thanks to team XODUS for helping me out !
This post has been edited by candyman on Oct 1 2003, 02:18 PM