Group: Members
Posts: 1351
Joined: 6-May 05
From: FunkyTown
Member No.: 219087
Xbox Version: v1.0
360 version: none
QUOTE(capboy210 @ Dec 28 2005, 03:44 PM)
(edit) it wont go on this mobo, the heatsink was in the way of the chip so i couldnot conutinue with install.
also i decided to use an x3 vs xenium
When your heat sink is in the way, tsop it.
I don't see what it is in the way of really but I know for a fact you could tsop it, and use 5035's, you have your self a bad ass little box. With a lot of the same functions as an X3
Group: Members
Posts: 827
Joined: 2-December 05
From: Colorado
Member No.: 261402
Xbox Version: v1.0
360 version: v1 (xenon)
im going to put it on my other 1.0 mobo witout any obstructions, plus id rather fuck up on that mobo cause the heatsinks get hotter because of not as much goo contacting the chips, i will fix that later...
Group: XS-BANNED
Posts: 1795
Joined: 30-April 05
From: Haha
Member No.: 217740
Xbox Version: unk
360 version: unknown
Paint the front panel and the little clip on piece around the buttons to match the top color. Also, Paint the bezel and then sharpie over the letters to make them black or silver again. Then remove the xecuter control panel and if you use it, then place it in the back.
Group: Members
Posts: 179
Joined: 17-October 04
From: Alma
Member No.: 157021
Xbox Version: v1.0
360 version: unknown
Here is the link to my XCM Clear Case with some LED's Clear XCM case link I have a few pics there and it would just be easier to post a link and 1 pic here then all the pics here.
Group: Members
Posts: 411
Joined: 24-July 05
From: Dallas
Member No.: 236559
Xbox Version: v1.0
360 version: unknown
thats not too bad. a couple of flaws i see, i dunno if it's the camera or what. There looks to be a ring of something...hot glue maybe?...around the underside of the jewel. kinda detracts from it. Also, most of your paint edges, where the silver meets the black, and the silver inside the fin channels looks a little rough. almost like you did it freehand instead of using a straight edge(tape, sheild, stencil, etc. )
other then that, not a bad box! i might have painted the faceplate in a similar manner, like blue on the inside of the face but not all the way to the edges, so it remains cohesive.