QUOTE(Heimdall @ Jun 27 2011, 07:53 PM)
You missed the bit where you put the stock dash files in the appropriate places before you build the iso.
Xboxhdm 3 is still experimental, so if your PC only has one IDE port on the motherboard then you should use xboxhdm 2.2.
yup i did use 2.2 and all went fine , i have the 1 of the non bricked ones softmoded now
im leaving the other working one for now and concentrating on the bricked one
i like a challange
with the bricked one all starts well in xboxhddmaker
it comes up and tells me that st310014a is the primary master which is dev/hda
then when i try to do option 1 it says
" Building an xbox Hd from scratch is a two step
Procedure. First the partition table is built.
Then the partitions are formatted.
We will now search /dev/hda for an xbox partition table...
No xbox-partition tabe found on /dev/hda
Drive is not locked but locking enabled
Dont Reboot until you have build a working xbox hdd
Since Rebooting will relock the drive
Press any key to abort the operation.... "
i tried to wipe the fatx partition and do it again , but still same error
as this machine wont boot to dash i unpluged the dvd drive to force an error 12 , to make sure the drive was unlocked before i hotswaped
so im at a bit of a loss atm
are there any linux commands i can send to reformat / repartition the drive