hi all.i have built a xbox 360 arcade machine (or should i say over half way through) and i want to use a 3.5 8-gb hard drive i have lying around.now the machine is a falcon with the rgh hack so all good there.
Anyway is it possible to use the original hard drive connector from inside a xbox 360 hard drive and connect it to the 80gb hard drive? obviously i need 12 so could i find the 5v wire and cut it then connect it to 12v therefore leaving all wires original apart from the 5v wire then becomes the 12v? hope this is possible as i don't fancy removing board to solder underneath.
Thanks once again