Duox2 Bios On Bank 0 Messed Up And Bank 1 Empty, BAD BIOS ON BANK 0 AND NO BIOS ON BANK 1 Options

[shambles1980]

are you booting from a working chip or from the softmod?
if your booting from a softmod you need to put the chip on the lpc header before you can flash it..
I would personaly do that when i see that its starting to boot the softmod bios should have been loaded to memory by then. The chip has to be connected fully so its probably best to have d0 connected and bt connected to ground on the chip so its always on. then when the xbox starts to boot properly attach the chip to the lps header,
then just flash as norma. (with the correct 1.6 bios)

[bentheman]

i press eject=softmod boot
i press power=chip boot

[bentheman]

i get what ur sayin now take chip off header to boot soft mod once in softmod connect chip back on soo i dont boot the bad chip bios i think i get it now

thanks man

This post has been edited by bentheman: May 14 2012, 07:22 AM

[shambles1980]

your bt point must be straped to a smd resister or to the back of the power buttoon for you to dual boot like that.
So you may want to strap bt to ground or pin 1 on the quick soler points on the chip.
(i think its pin 1, souble check that)
then the chip is always on and not dependant on a bt signal from a diferent button press.