1. Download all files into the same folder.
2. Start a Command Prompt in Windows in that folder with administrative rights.
3. Run diskmgmt.msc. Take note of the Disk number corresponding to the xbox hdd, for example Disk 1 by using the drive size as a guide.
xboxdumper prepare \\.\PhysicalDrive1
Make sure the first line of output is
Written -> BRFR
where PhysicalDriveN represents the xbox hdd, the number N must match the Disk number identified in step 3. In this case, N is 1.
5. Installing Kingroach's Ndure with xplorer360. If you are using Windows 7, you may need to disable UAC to enable drag&drop.
a. Open xbox hdd with xplorer360. Backup contents of C drive (partition 3). You might substitute msdash files from CASH disc in place of the backup of C drive.
b. Close the drive in xplorer360 and open shadowc.img in shadowc folder of ndure C folder with xplorer360.
c. Copy backup files from step 1 over to partition 0. Close the image.
d. Open xbox hdd with xplorer360 again. If you want ndure to coexist with existing msdash, delete xbox.xtf and xbox book.xtf in partition 3 and then copy over contents of ndure C folder over to partition 3. and take care ernie.xtf is copied before xbox.xtf. Otherwise delete away contents of partition 3 and copy over Ndure C folder contents over.
e. Copy ndure E folder contents to partition 4.
f. For setting up of UDDAE,
g. Copy xboxdashdata.17cdc100 folder in ndure C folder to partition 3.
h. Copy settings_adoc.xip from ndure C folder 's xboxdashdata.185ead00 folder to same folder in partiton 3.
i. If on partition 4, under TDATA/fffe0000/music folder , ST.DB exists, rename to ST2.DB.
j. Copy ST.DB from ndure E folder TDATA/fffe0000/music folder to same folder on partition 4.
6. Lock the hdd with hdtool.
will identify the hdd. Eg:
HDD Serial : <blanked out>
HDD Model : Hitachi <blanked out>
Drive Security Settings
Security supported : yes
Security enabled : no
Security locked : no
Security frozen : yes
Security count expired: no
hdtool -e eeprom.bin -p LOCK /dev/hdc
hda represents IDE primary master.
hdb is IDE primary slave.
hdc is IDE secondary master.
hdd is IDE secondary slave.
If xbox doesn't boot, use a hex editor and insert BRFR at offset 0x600 of the hdd. You have to unlock the hdd first with
This post has been edited by ldotsfan: Mar 29 2010, 02:57 PM
hdtool -e eeprom.bin -p DISABLE-PW /dev/hdc
hdtool -e eeprom.bin -p UNLOCK /dev/hdc