My Keyless Starter Project Options

[commandersafi]

I have been working on this for a little while now and i thought i would post up whats been done so far. I figured you X-S guys would like to see it

Took a lot of work to get it the way it is now but not done yet. Tonight i plan on making my custom pieces to hold the switches in place. I just ordered a momentary pushbutton switch, so until it comes in i have to just touch the wires together

Heres a quick vid. i made while i was pulling the stang back in the garage after washing
http://s84.photobucket.com/albums/k5/comma...nt=MVI_0744.flv

This post has been edited by commandersafi: Apr 5 2009, 05:35 AM

[ubernewb]

i'm guessing you just tied all the acc and ign wires together and put them on the switch?

[w2kj]

...and did you add an anti-theft device; ie a starter disabling device?

[throwingks]

What happens if your girlfriend's right elbow hits the switch when you are driving at 95mph down the highway?

[commandersafi]

i'm guessing you just tied all the acc and ign wires together and put them on the switch?

Something like that. But since this is a newer car theres like 11 wires going to the ignition cylinder so i had to set all this up using relay's and what not

...and did you add an anti-theft device; ie a starter disabling device?

I havn't put one in just yet, but i have a plan on a pretty neat trick. Lets just say it'll involve the special placement of a magnet before you can start

What happens if your girlfriend's right elbow hits the switch when you are driving at 95mph down the highway?

Push clutch in as fast as i can
I may set up a fail-safe type thing too keep anything like that from happening.

[commandersafi]

Well...lots been done
http://s84.photobucket.com/albums/k5/comma...=1239748613.flv

This is as far as im going right now until i can get the tuning software to disable PATS