I tried to install an Xbox Xtender today on my v1.4 Xbox running Xbit Mod.
Instructions advised me to solder a wire to the side of the resistor which resides at R3G3 on the Xbox mobo, and yup you guessed it, I managed to FRY the resistor.
I need to buy a replacement resistor so need your advice. I know its a 10,000 ohms (10k ohms) resistor but do I need to get any particular wattage /voltage and make ? Also any ideas where I can pick one up in the UK ?
Or is there a way of bridging the resistor point with wire ? (Sorry im hopeless with electronics hence the accident !!!)
The Xbox seems to power up when I press the Eject button but then it switches off after 20 seconds.
I look forward to hearing from you all
many thanks in advance
This post has been edited by nmacog: Dec 12 2005, 08:43 PM