QUOTE(Exige_ @ Dec 11 2008, 05:56 PM)
Yeah that diagram doesn't make sense to me
it's like this guys
yellow wire --> resistor/s --> here you connect all of the LED positive (long legs) connections and also add the wire you ran to pin 11 --> negative (short leg) of LED's wired together to connect to black wire
xTKxhom3r you have it all right, but instead of connecting the wire which goes to pin 11 to the negative side of the LED's, connect it to the positive side of the led's, after the resistor....on the LED side of the resistors....
so the power flows from yellow, into resistor, and then when HDD is active and pin 11 goes to 0v the power flows to ground, it never gets to the LED's, which is why they go out, then when the HDD is not active there is 2.66-2.7v on pin 11, which means the power will naturally flow towards the closest ground, which is on the other side of the LEDs, the black wire....which is why they stay lit when the HDD is inactiveThis post has been edited by jamesnmandy: Dec 12 2008, 01:49 AM