What is the best Method For Updating Dual/triple Nand Systems Options

[BoNg420]

I ask this because I read you had to raise the LDV of the RGH side of the console first or whatever is on your other NANDs before you do your retail nand.

Is it better to update the NAND on other NAND(S) first by flashing through xell or is it better to physically hook up a programmer to do it.

I am questioning this because I did the update through xell on a triple nand system after raising the LDV on my RGH image and it was fine and booted, but then I went to try the retail dash it raised the LDV before I updated that side and wouldn't boot and I had to dick around for awhile messing with different images until I got the retail side updated right.

Why did the LDV raise when I flashed the image in Xell for the RGH NAND? Is it because of the way I flashed it or is it because I tested out that dash before updating the retail? Also I notice there are 2 places you can change the LDV value, which one is the correct one to raise?

Thanks for any help provided on clearing this up.

This post has been edited by BoNg420: Jun 7 2012, 03:55 AM