I just would like a quick yes or no answer to this question (based on the details given here).
Note, I have gone through the FAQs and Tutorials and searched the forums quite a bit. I have seen it mentioned that you can flash the bios using Evox, but I haven't seen any direct confirmation that you can use the Chips second bank (that still has the cromwell flash bios on it) to reflash the first bank.
I have an Xecuter 2.2 Lite, with external switches that I flashed bank 1 (A&B) with a (mostly) properly prepared 512K bios image of X2 4980.67.
Xbox boots Evox from CD-RW just fine, and will also boot to Cromwell Flash Bios if I switch to bank 2 (C&D).
My goal is to boot Evox from the E: partition (apparently you have to configure that in the bios image)
I would prefer to completely leave the C: Partition alone until I install a new HDD
Can I just repeat the flash bios procedure outlined below?
a. Create 512K image of new bios (with configuration changes)
b. Create ISO (no multisession) with 100MB Dummy file.
c. Burn to CD-RW (Verbatim)
d. Set switches to Unprotect and Bank 2
e. Power on Xbox
f. When drawer opens insert new Bios CD-RW and close
g. Wait for xbox to flash bios and power off (because I won't have any errors, right?)
h. reset switches for normal mod-chip operation (Protect and Bank1)