When flashing my 1024k bios I have it set so that just DIP switch 4 is on and the chip is disabled, so that's fine. Then if I have a 1024k file..I try booting up EVOX with only DIP switch 3 on and the chip is enabled. I haven't tried a 512k bios yet but like I said ...I open the 256k across all 4 banks, read it, flash it, and verify it and all is well. It's this damn red/;orange flashing thing. Another reason can be bad connections but I wouldn't be able to flash and detect and verify it through x2 BIOS manager if the soldering was jacked up right? So I'm just thinking BIOS. Also, I did get the Cromwell BIOS load up after I installed the chip < I just chose to do the LPT/parrallel cause of ease, and X2 BIOS can detect the chip (x2.3b pro) so d0 shoud be fine too as well as all connections.
This post has been edited by louisj23: Jun 10 2004, 06:40 PM