I got xbox modded with somekind of homebrew chip.
Layout for soldering in the chip end seem to suggest that this would be "homebrew eeprom" chip. (not Xtender or Enigmah). Im not 100% sure though.
This is the layout i have: ->picture<-
is there further checks i should make? Or am i ready to go?
Oh and after i have enabled TSOP flashing by bridging the spots from _both_ sides of motherboard and booted, I should cut few wires. 16 and 32 if im correct?
But much rather Id like just remove the homebrew-modchip from socket.
(there socket for simple replace of eeprom chip (perhaps designed for upgrades)) if this is an option?