Ok, i just installed my x-chip with pin header on a 1.6 xbox and when i power it on it frags red/green.
I read that if it frags, it means that the d0 solder is fine. Is that true ?
Also i see the red light of the chip lighting each time it frags: does it also mean that the 5v connexion is ok or not necessarily ?
I am also a bit lost about what to do just after i install the chip. Do i need to flash the bios so it stops fraging ?
Also one last question: i read on the chips table on xbox scene that it needs 1.1 cromwell on 1.6 xbox but i am unable to find anything but 1.0 cromwell on the 2b2k website !
Since i don't have a ohm checking device i can't test my solders and would like to be sure that it is a soldering issue before i redo them all
TIA for your help guys This post has been edited by CoolSpy: Aug 10 2005, 12:35 PM