|
i purchaced a xecuter lite 2.6 ce chip about 2 weeks ago and installed it on my xbox everything was fine when i soldered the pin header hd wire and lan wire then it came to the d0 point i soldered it down then tryed to turn on my xbox. failure so i was gonna resolder the d0 point when i lifted the pad so i researched for a few days and did a trace repair. frag again i thought it was just a bad solder job so i read that you should scrape your top trace point untill its copper, well i started scraping the point and the point dissapeared so i kept digging into the motherboard and still nothing i got about a half cm into the board and stoped because i was afraid to mess anything on my xbox up i have no clue what happend to the point but i was wondering if there is a alt soldering point on the top of the motherboard. the trace that i was reparing is the one above the one in which you solder the d0 wire to somehow i managed to remove 2 so i had to do 2 trace repairs
|
I Messed Up Both Trace And Do Points, is there anyway to fix this
Oct 5 2005, 02:50 AM
