Vga Controller Mod For Your Old School Controllers Options

[pimpmaul69]

ok first off i want to thank the guy who did the six button genesis controller vga mod @ xerxes3rd.net.. he beat me to a vga tut so he gets credit for that.. i will however elaborate way beyond what he did. to start i will show a tut on a genesis six button, a nes , a snes, a saturn, a sega mater system, an atari 2600 and an atari 7800 controller..

first thing you need to know is my wire color pinout:

------- BLUE -------------------- +5V

------- EXPOSED WIRE -------- GROUND

TP63 - RED -------------------- LEFT TRIGGER

TP19 - PINK ------------------- BACK

TP64 - GREY ------------------- RIGHT TRIGGER

TP18 - BROWN ---------------- START

TP13 - BROWN/WHITE ------- UP

TP15 - WHITE ----------------- DOWN

TP16 - TURQUOISE ----------- LEFT

TP17 - ORANGE --------------- RIGHT

TP69 - GREEN ----------------- BLACK

TP72 - YELLOW ---------------- WHITE

TP71 - RED/WHITE ------------ Y

TP70 - BLACK/WHITE -------- X

TP68 - PURPLE ---------------- B

TP67 - BLACK ----------------- A

take the female end of your vga cable cut it and very carefully strip it like this


now take apart your fatboy controller and remove the memory card casing and shove your vga cable in the bottom memcard slot like this



Now go to here
anduse the 2 pics to find the solder points on the fatboy controller.. he does not show the l and r triggers but you can find them really easy. remember use my wire color scheme not his.. otherwise my whole tut is a waste of your time.desolder the 5 pins off the bottom usb memcard and snap off the memcard port


now that you have the fatboy controller done it is time to do the old school controllers.
on the old controllers you may need to remove the old chip.. also removing the old wire pins is optional you can just snip them off. ok the fastest and best way to remove a chip is with a heatgun or a blow dryer..once the chip heats up enough you can easily pry it right off without damaging the solder pads

and if you choose to completely remove the old wire pins you can use a desoldering iron (my personal choice) or a desoldering braid. otherwise you can just snip the wires off


now on the rest of the tutorial all i am going to show you is the controller and its circuit board with the color wires that get soldered to each one.. light grey represents the bare ground wire.



an nes controller





a snes controller





This post has been edited by atomiX: Jun 27 2006, 03:06 AM

[AciDBoy]

Hi I had a few questions.

1. I have a female 15 pin vga port and a male vga 15 pin port also. I bought them from radioshack. Anyway I had a question they don't have wires so I really can't understand your schematic. I was wondering what pins would do what. I've seen a lot of pictures of the pins usually right to left 1-15 but I can't find one with the pins laid out with wires attached.

2. Also if I install a vga port into my duke can I still use it for games such as halo and stuff then could switch it with a different controller via vga if possible for my homebrewed games?

3. Is there a tutorial on how to install a vga port and a headphone jack inside the xbox? Or just a headphone jack? I would really like pictures if possible I've always seen schematics but they really don't give me the best understanding.

4. If I installed a vga port inside the xbox could I use it on normal xbox games and movies? Or do I need special bios. Would I need a modchip? Or could I be able to tsop flash the xbox with it? If a modchip is needed would a duox2 lite work or a duox 2?

5. If I just install a headphone jack could I be able to choose between tv or headphone?


thanks in advanced.