Well i got my Xecuter 2.6CE in this morning, and might i say i was a little afraid
It got really bad when i opened the package (I HAD NO IDEIA THAT THEY WERE THAT SMALL!)
well since i have a 1.0 i took the solder out of the ports, put the pin header in and i was on my journey
well 5 mins later im done, and im like 'no way was it that easy' and it looked EXACTLY like the picture in my manual
so then i solder the d0/hdd/lan cable
the hdd and lan cable were EASY, the d0 was hard, i had to put a litle extra solder on it
well i connect everything and screw everything in and close the case
done
boots up in less than a sec and i see flash bios, i do the flash via http and it WORKED
now i have everything in my sig complete, and the bios on bank 2 is FlashBIOS 3.0.3
im so happy
Dont Need Help
Jun 20 2006, 08:20 PM
