QUOTE(DanITman @ Mar 17 2007, 06:30 PM)
Please correct me if I'm wrong but it's my understanding that you would program the chip once it is soldered on the other chip. The switch controls which firmware chip gets power. Either way you have it switched will determine which one is being programmed.
No, the switch controls which tsop is enabled, not which one gets power. Both chips are powered when the 360 is turned on but only the tsop that is selected is able to be read or written to.
I would imagine that, espically for a hitachi, it has to be flashed externally first.
Caster.This post has been edited by caster420: Mar 18 2007, 07:51 PM