xbox-scene.com - your xbox news information source
Quick Links: Main Forums | Xbox360 Forums | Xbox1 Forums | PS3 Forums
Xbox-Scene Forum Help  Search Xbox-Scene Forums   Xbox-Scene Forum Members   Xbox-Scene Calendar

Giganews Usenet Offers: +1150 days binary retention, 99%+ Completion, and Unlimited Speed/Access!

360 ODD Emulators: X360 Key $99 | Wasabi360 FAT $99 | Wasabi360 Slim $99
C4E's iXtreme Burner MAX Drive: LiteOn iHAS124 DROPPED TO JUST $17


Welcome Guest ( Log In | Register )

 Forum Rules Rules
 
 Reply to this topicStart new topic
> Duox2 1.6 Install
cubsfan23
post Mar 18 2007, 11:53 PM
Post #1


X-S Enthusiast


Group: Members
Posts: 5
Joined: 16-March 07
Member No.: 334447
when installing the lpc rebuild do you first solder the pin header to the motherboard or the lpc rebuild to the motherboard?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
jwhazel
post Mar 19 2007, 08:14 AM
Post #2


X-S Young Member
*

Group: Members
Posts: 31
Joined: 20-September 05
Member No.: 247360
Carefully solder the pin header (make sure the solder is very thin, just enough to make contact) to the motherboard. Then install the LPC rebuild.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
appleguru
post Mar 19 2007, 09:45 PM
Post #3


an Apple a Day...
******

Group: Members
Posts: 2694
Joined: 15-July 04
From: Colorado Springs, CO Boston, MA
Member No.: 130591
Xbox Version: v1.6
360 version: v1 (xenon)
I usually solder the pinheader and LPC rebuild at the same time, but that method makes most sense with 'open' rebuild pcbs like the xecuter ones... With the duox2 pcbs, LIGHTLY soldering the pinheader in first makes sense to ensure a good connection. Do NOT put too much solder on the first time though, or you wont be able to put the rebuild pcb down.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
_GhOsT_
post Mar 20 2007, 03:18 AM
Post #4


X-S Genius
****

Group: Members
Posts: 970
Joined: 14-June 05
From: •°•°•°•°•°•°•°•°•
Member No.: 227302
Xbox Version: v1.6
360 version: v4.0 (jasper)
just solder in the pin header then do the rebuild with wires
if the install goes bad with the rebuild board its way harder to take off, than wires would be
User is offlineProfile CardPM
Go to the top of the page
+Quote Post




 

Reply to this topicStart new topic

 

Lo-Fi Version Time is now: 23rd May 2013 - 09:07 AM
Invision Power Board v2.1.7 © 2013  IPS, Inc.
Licensed to: Scenyx