QUOTE(henmill @ Jun 23 2007, 05:43 PM)
carries everything you described
THAT'S IT! Thanks!
I was planning on getting the Red/Blue LEDs off the sight. They are 4000mcd 20mA 2.1V-Red 3.3V-Blue. The site has a resistor calculator on there but the only problem is I'm not sure about the voltage that is supplied to the stock Eject/Power board on the xbox. I'm assuming it's 5v but I'm not sure enough to just assume that and go with it. I'm sure there is a thread about this already though I've missed it when I've gone looking for it.This post has been edited by tc154: Jun 23 2007, 06:51 PM