Region Change From Eu To Us Sucess... Clean Guide Here.., instruction for changing the region from eu to us and others..... Options

[bluemimmosa]

The steps are....

1. prepare jtag hack and parallel port.
2. plug the parallel port on your computer.
3. plug the power supply brick but dont turn your 360 on. (let it be off).
4. open the command prompt.
5. backup your nand 3 or 4 times as nand1.bin, nand2.bin, nand3.bin and nand4.bin. ("nandpro.exe lpt: -r16 nand1.bin")
6. use "fc /b nand1.bin nand2.bin" on command prompt after backing up ur nand is finished.
7. compare every with each other and find the identical ones.
8. if u get two or more identical then rename them to fresh1, fresh2 etc.
9. flash xell to ur xbox360. ("nandpro.exe lpt: -w16 xell.bin) (only do if u have got two or more backups of nand identical)
10. turn ur 360 on connecting to a vga cable and monitor.
11. grab ur cpu key from fusebits.
12. open the fresh nand image on flash tool after setting 1bl key (same for every 360) and ur unique cpukey.
13. click on patch button
14. click the kv section and change the region to desired and press ok.
15. now save ur modified nand image as mod.bin
16. remove the 3 330ohms resistor from ur xbox360.
17. flash ur modified nand image. (if error while writing erasing ur nand may help. "nandpro.exe lpt: -e16 0x000000")
18.after flash is sucessfully completed turn your 360 on.
19. voila ur xbox 360 is on and have your desired region.

note: if any problem occurs (3RROD or E79) then erase your nand and try again.
note: patience is very needed. try until u get sucess.

note: i sucessfully changed a eu region console to us region through this procedure.

please post thanks if u like my post.

[fahrenheit]

Much appreciated.

I look forward to using the guide in the very near future.

[iraqeez]

is it 4 xenon mobo only?
nice job
thanx

[modguru.gr]

[quote name='bluemimmosa' date='Oct 14 2009, 08:45 AM' post='4543447']
The steps are....

16. remove the 3 330ohms resistor from ur xbox360.

are you soure about that ?

[lilhaywood]

The 330 resistors are to run the modified nand's. since your just flashing your new one on should be fine.

[bluemimmosa]

@ modguru.gr


Those 330 ohms 3 resistor are for booting into xell only.
since you are writing back your original nand modified so you can remove that...

@ iraqeez

these applies for all board just replace thoser 330 ohms with other mobos diagrams..

[iraqeez]