Group: Members
Posts: 105
Joined: 1-December 08
Member No.: 397630
Xbox Version: v1.3
360 version: v4.0 (jasper)
Alright folks, i have a zephyr which had a liteon dvd drive that i messed up while bridging the two points. The component to the left of the two r707 points was lost in the fiasco. I unfortunately have the new update. I have heard that you can still dump the nand and get the dvd key from a couple of sources. Is that true?
Group: Members
Posts: 105
Joined: 1-December 08
Member No.: 397630
Xbox Version: v1.3
360 version: v4.0 (jasper)
WTF?! It was only a 100 ohm resistor!? Damn, i feel like an idiot. I thought it was an smd cap. I do happen to have a pack of 1/2 watt 100 ohm resistors. Would those do? The solder pads were knocked off from the looks of it though. I would have to solder to the via and the trace wouldn't i? By the skill do you mean i would have to have cygnos v2 to get the key off the mobo? I heard you can only get it with a secondary hacked nand.
Group: Members
Posts: 2326
Joined: 6-November 03
From: Niagara Falls
Member No.: 72412
Xbox Version: v1.6
360 version: v3.1 (opus)
Oh yeah, i knew what you did right away. I repair these as a full time job. You can use a 1/2 watt and yes just solder it from the via and go right to the correct pin (the one next to TxD)
cygnos v2 would not be needed if it did come to mb key extraction but lets no even go there unless this repair i suggested fails.
Group: Members
Posts: 105
Joined: 1-December 08
Member No.: 397630
Xbox Version: v1.3
360 version: v4.0 (jasper)
Okay, so i got the resistor replaced but now it will not eject. After i accidentally knocked off the resistor, i plugged it in thinking it was no big deal but now it will not eject. Did i fry the motor that ejects the disc drive?
This post has been edited by SDOD616: Nov 5 2009, 11:14 PM
Group: Members
Posts: 2326
Joined: 6-November 03
From: Niagara Falls
Member No.: 72412
Xbox Version: v1.6
360 version: v3.1 (opus)
You wont fry the motor. The controller chip on the other hand is very easy to piss off. Most of the ones i repair for customers i can get the key but they never eject again. Not sure what people are doing to these things.
You should still try and read the key. Manual eject the tray to half and give it a try.
You might just end up being better off to get a new drive off ebay and shipping it to me to see if i can get it.
PM me if you want to go that route. Drive board can be shipped letter mail from USA to canada for $1.50
Group: Members
Posts: 105
Joined: 1-December 08
Member No.: 397630
Xbox Version: v1.3
360 version: v4.0 (jasper)
Well, i have an extra ms28 that i can probably spoof. I am looking to get the motherboard dvd key. Are you sure it still works with the August 2009 Update?
Group: Members
Posts: 2326
Joined: 6-November 03
From: Niagara Falls
Member No.: 72412
Xbox Version: v1.6
360 version: v3.1 (opus)
QUOTE(SDOD616 @ Nov 5 2009, 06:16 PM)
Well, i have an extra ms28 that i can probably spoof. I am looking to get the motherboard dvd key. Are you sure it still works with the August 2009 Update?
Nope, after august update you can't get the key from the motherboard anymore
Go to system settings > system info. If your kernal is 8498 or higher then there is no way at this time.
Group: Members
Posts: 105
Joined: 1-December 08
Member No.: 397630
Xbox Version: v1.3
360 version: v4.0 (jasper)
How much will you charge if i were to send you the liteon board to retrieve the key from? All you need to do is get the key from that one chip right? If so, you can just email me the key. I won't need the board back though.