QUOTE(modslave @ Mar 20 2010, 02:21 AM)
Too late. I was holding out for one these 2 months ago but not anymore.
And now without the dual nand its just another usb flasher
Yes, does that mean that this "single" NAND is _JUST_ a flasher? i.e. No cygnos NAND anymore? As far as I knew, the cygnos only had 1 NAND to begin with, if you take that one away, then only the XBOX's NAND is left. Is this correct, or is just the functionality for dual NAND missing?
Also, it says to dump a 16MB NAND, it takes 2 mintues? It only takes like 20 seconds on the ones out now.
QUOTE(LiarInGlass @ Mar 20 2010, 02:18 AM)
What exactly does the quicksolder pads mean?
I'm considering picking this up to mess with instead of building one since I'm clumsy, but I'm confused by what the quick-solder pads means?
I wouldn't buy this if it really only flashes the XBOX NAND. Anyways, these are just spots you solder directly from the Cygnos to the motherboard. This can already be done however, you don't have to use the top of the board if you are using 30awg for those spots (they fit anyhow).
QUOTE(letsmod @ Mar 20 2010, 02:13 AM)
I have my full stock of cygnos Rev F, anyone have the install manual???? they still dont have them online
E-79 is still an issues, but the last console I did I replaced the jumper with a 100ohm resistor and fixed my E-79 errors
Looks like the installation is identical, just have the quick solder pads for JTAG. I would still think you have to short 2 of those JTAG quick pads, not sure though. Of course, what about using diodes or resistors with the new JTAG quick pads? Unless by some miracle you will never need them again, you will not have much room to install them. And yes, it would be nice to have a manual for a product you are selling! I don't see it listed either on their server. I do see "lt.rar" though, and it's encrypted. Of course, they wouldn't have anything related to piracy or security circumvention in that file, they are so honest right? (That _IS_ a joke ) http://www.cygnos360.com/Downloads/This post has been edited by Julets: Mar 20 2010, 04:45 AM