Xecuter 2.6 Doesn't Boot After Unrelated Mod Options

[InspectorMustache]

Hi!

I've had an Xecuter2.6 in my box (1.4) for a while and it worked fine. Yesterday, I installed the pulseVU mod in my Xbox. In the process, I temporarily removed the X2.6 from the pin header. After I was finished, I put it back on there but now when I turn on the XBox, it starts, shuts down, starts again, shuts down, and finally starts again with the front led blinking red/green and not displaying anything on the screen.
I've had this problem before but it was always gone after I adjusted the chip's positioning on the pin header a little bit. Now even that won't help.

To check if it had anything to do with a faulty pinheader, I installed the chip in a different XBox with a wire install but it's the same there.

So, that means I need a new chip, right? Just wanted to be sure, before I waste 30 euros on a new Xecuter.

By the way, the pulseVU works fine... but who cares about that without a working modchip...


Thanks in advance for any help. It's greatly appreciated.

[big F Mk II]

I have the same issue with my 2.6 lite chip, it just wouldn't boot one day after 2 years of being fine.

I posted on here and nobody posted a reply.

I have since bought a programmer for the chip and put in several bios'es all check out ok but it refuses to boot.

Now if I find out why I'll post here to say why and what.