Jtag Nandpro Problems Options

[scrimpus]

this is my first jtag, i have an exploitable xenon, ive connected my ltp cable and now every time i plug the 360 in it turns on, every guide ive read says to plug it in but dont turn it on, is this normal for it to turn on when its plugged in? Also every time i run nandpro is get the could not find flash controller cannot continue error. I have tried every option in bios i get the same error, i checked my soldering, everything looks fine, any help would be greatly appreciated.

[evertonman67]

I would re-check your soldering with a multimeter and make sure that your getting a read out on it.If your getting any zero's on any of your solder points,then you'll know where your problem is.Also make sure that your JTAG and LPT wires are pushed right into the holes on the board and not just soldered to the top,just double check that each wire is pushing through the bottom of the board just by a very small amount only,don't push them through to much.