QUOTE(sneakypeanut @ Oct 2 2011, 07:23 PM)
what problem u having with the smc_config editor?
Copied from original Exploit 360 188.8.131.52 post on here....
SMC Editting is a total fail for me.
Here's what I did...
Selected Xell-Reloaded, Standard, Falcon...
General Options USA
Checked Use SMC Config Editor...
For Testing I Changed Thermals to
50, 52, 55
And Cut Out Temps to
080, 082, 085
Changed Region to 00 (RF)
Clicked Next and let it build the bin.
Saved it, then opened it with 360 Flash Tool v0.97
Thermals were 50, 52, 55... Cut Offs were 050, 100, 102
Region was 01
This really boned me when I flashed 13599 to my box and was getting constant 2RROD overheat errors. Took a couple days of screwing with heatsinks and getting ready to send it out for another reball before I checked with Flash Tool and found bad Cut Out values. So I built a couple bins with your tool and there was always at least one Cut Out that was copied over from the Thermal side.
I'm still gonna use it, but I'll stick with Flash Tool for smc mods for a bit.