Xaio360 - All in One Flasher/Glitcher/JTAG Chip Options

[Xbox-Scene]

Xaio360 - All in One Flasher/Glitcher/JTAG Chip Posted by XanTium | January 26 20:31 EST | News Category: Xbox360

The Rebug team, know from the ps3 scene, officially unveiled their all-in-one (Flasher, RGH, JTAG) Xbox360 chip on xaio360.com: [QUOTE] Features: • Opensource Firmware • JTAG Programming of onboard Xilinx via USB (No external programmer needed) • SPI Progamming of Xbox360 NAND via USB (No external programmer needed) • Fast swap between SPI and JTAG modes with a press of a button • External Oscillator (Wiring to HANA is no longer required) • Firmware upgradable for future XAIO 360 updates (No external programmer needed) • 100% Compatible with NAND Pro v2.x (3.0 is NOT supported!) • Compatible with all Xbox360 models (Except Xenon and Corona boards) • Booting of unsigned code on Xbox360 • Compatible with all Xbox360 kernel versions • Glitching of all compatible Xbox360 models is usually within 3-25sec • Easy 7 wire SPI installation for both PHAT and SLIM • Easy 5 wire RGH installation for PHAT, 6 wires for SLIM • Works as 6 wire JTAG-Interface using UrJTAG software (4 signals + power (TDI, TMS, TCK, TDO, VCC, GND) *Required patched version of UrJTAG will be downloadable from our website. • Compact size of 47mm x 32mm (1.84″ x 1.28″) [/QUOTE] Official Site: http://xaio360.com

[phrozenfeonix]

• External Oscillator (Wiring to HANA is no longer required)
...
• Compatible with all Xbox360 models (Except Xenon and Corona boards)

These two features seem to clash for me. If it's HANA independent, then shouldn't it be compatible with corona 360s?

[boflc]

xenon: no. read through the original release notes: the cpu doesn't like being slowed down.

corona: no (at least currently): there is no corona-compatible CB for glitching yet. further, the 4gb corona's have a new flash controller that has yet to be reverse engineered. cory1492 said that it does respond to SPI commands at some point, but that it still needed to be RE'ed.

[phrozenfeonix]

Gotcha. The other chip on that market that shows off rgh on a corona made me assume it was only a lack of timing via the HANA chipset that was the only stepping stone. My mistake.

As for Xenon, I though it was a given xenons were never going to be RGH'ed?

[burnshroom]

Wouldn't RGH'ing a Xenon be like trying to put nice rims on your uncle's old 1972 Nova. Sure it looks nice but it won't last long enough to be enjoyed...

[DARKFiB3R]

Wouldn't RGH'ing a Xenon be like trying to put nice rims on your uncle's old 1972 Nova. Sure it looks nice but it won't last long enough to be enjoyed...

Add rep, +1, like post. Where are these buttons when you need them?

On a side note, it has a v nice logo.

[pigbait]

Wouldn't RGH'ing a Xenon be like trying to put nice rims on your uncle's old 1972 Nova. Sure it looks nice but it won't last long enough to be enjoyed...

You mean Toyota corolla, novas are a nice cars it will out last your 1998 cavalier/sun fire.

[kronolynx]

• JTAG Programming of onboard Xilinx via USB (No external programmer needed)
• SPI Progamming of Xbox360 NAND via USB (No external programmer needed)

so we will be able to RGH our xbox without the need of external hardware ?
no need for nandx to dump the nand or program the chip ?

did i understand right ?

[SNAAAKE]

so we will be able to RGH our xbox without the need of external hardware ?
no need for nandx to dump the nand or program the chip ?

did i understand right ?

yes sounds about right. good for people that dont own any programmer.

personally I will stick to tx coolrunners until someone figures out corona boards.

[kronolynx]

yes sounds about right. good for people that dont own any programmer.

personally I will stick to tx coolrunners until someone figures out corona boards.

i want to RGH my xbox so this is great for me, i didn't want to buy a programmer to use it only once.

[Morning Call]

this is an all in one board. it will do the whole process from start to finish. all you'd need is this board to glitch your console.

the external clock is just for less wires to install with 'possible' corona support for future if anything happens.

[40_ounce]

Sounds good time to buy another 360. Now we just need a price. If it's the same price as the coolrunner then you can count me out since I have all the hardware already for installing the coolrunner.

[tech3475]

Wouldn't RGH'ing a Xenon be like trying to put nice rims on your uncle's old 1972 Nova. Sure it looks nice but it won't last long enough to be enjoyed...

I would still like to see a xenon version if it's possible since my one is banned and I don't want to RG my XBL console.

Of course with the CPU issue (I thought HANA was only used on slim consoles?) I doubt it.

[kronolynx]

Sounds good time to buy another 360. Now we just need a price. If it's the same price as the coolrunner then you can count me out since I have all the hardware already for installing the coolrunner.

i hope it has a similar price to coolrunner so i don't have to waste money on the nand-x which cost more than the cool runner.

[Blackaddr]

• External Oscillator (Wiring to HANA is no longer required)

I expect comments like this from simple simple copy-cat product manufacturers but Rebug is well respected in the PS3 scene. If they want to put an xtal onboard, it is one less wire to solder and they can choose a clock other than 48 Mhz if they wish. Cool, no problem there, they can state that as a value-add. The standby clock is used only because it's convenient, it has very little to do with the RGH itself.

As for stating that wiring to the HANA is no longer required? What do they think the I2C wires are connected to? I guess we could assume they simply meant wiring a clock wire is no longer required, if so the language used is misleading.

No one knows exactly what will be required for Corona support until someone has made it work. Suggesting "Corona" support in any way at this point is inappropriate.

Of course with the CPU issue (I thought HANA was only used on slim consoles?) I doubt it.

The chip on a Xenon is labelled "ANA". It takes digital video from the GPU and primarily performs digital-to-analog conversion. When they added HDMI support to the Zephyr, the HDMI functionality was added to the ANA chip and was renamed "HANA".

Corona still has a "HANA", it's just not separate chip anymore.

This post has been edited by Blackaddr: Jan 27 2012, 06:59 PM