Need Help With Slim Trinity And Rgh Options

[FrankDux]

Ok so I got the Xbox360 Slim (Trinity) installed the QSB and the CoolRunner-II connected it to the Nand-X v3 and read my nand several times.

Each time I read it i get :


Trinity
Reading Nand to F:\16gb usb\111-JTAG TOOLS\111-J-Runner v01 (259) Core Pack\J-Runner\output\nanddump1.bin
Arm Version: 3
Flash Config: 0x00023010
Reading Nand
Error: 250 reading block 178
Done!


its always the same block 178, I tried a few other programs and same block again.. I have re-soldered everything aswell.

but my big problem is when I select my nand files and that when I go to create the ECC file.. this is what I get

Initializing Nand..
*found flash image, unpacking...
ECC'ed - will unecc.
UnECC'ed
*found decrypted CD
*found XeLL binary, must be linked to 0x1c000000
*we found the following parts:
SMC: 3.1
CB_A: 9230
CB_C: 9230
CD (image): 9230
CD (decrypted): 8453
*this image will be valid *only* for: trinity (slim)
*patching SMC...
Patching Trinity version 3.1 SMC at offset 0x13B3

* XOR HACK NEEDED FOR CB 9230
* patching CB_9188..

(*** and then the J-Runner program crashes ***)


Im not sure whats going on...

any one got any suggestions

Thanks

This post has been edited by FrankDux: Mar 6 2012, 03:48 AM

[FrankDux]

Ok so I tried using all kinds of different lengths for the CPU RST wire, and tried even wrapping it around the fan shroud like someone suggested..

at 50cm wrapped around the fan shroud it actually booted 5 times in a row in 2-3secs but after that never booted again.

so i moved it around some more.. im back to having it coiled next to the xclamp like the diagram from TX show and its back to booting but takes a minute and doesnt always boot.


i also tried joining to wires together and the alternate points too. I redid all my solder points again, cleaned them all up.. doesnt change anything.

why is this so hard to get working. will a TRIM POT work instead of a long length of wire, if you run a small 8cm wire from CR-II glitch board to a small TRIM POT (which in effect is a section of wire that you can shorten the distance travelled by rotating the centre point) and then a small 2 or 4cm wire from trim pot to solder point on mobo.

????????

Thanks