I installed my coolrunner and flashed it with version A of RGH 2.0 and obtained 3 working copies of my nand ( I know they work because I flashed 2 of them back to my 360 and it booted up fine, however when I try to flash my xell ecc image using anything it seems, it just sits there and glitches forever (the green light turns on every 5 seconds). I tired 5Ohm resistor, 10 ohm resistor, 25 ohm resistor, I bridged the cap points and still no dice.
My dash is 14719 and my CB is 6753. I used multiboot to make xell image (modified for rgh 2.0). I tried flashing it using nandpro with no joy. I even restored my stock dash, and then tried to reflash the ecc file again with NO LUCK.
And please don't ask for pictures of my soldering. Its immaculate, as I do this for a living not to mention all of the tutorials and posts about wire placement. I want to try to build the ECC myself, but I honestly don't know where to look and google is taking me in circles. Any point in the right direction would be much apreciated.
Also, when I restore my default dash it glitches fine (The light flashe maybe 2 or 3 times and m$ dash loads).
When I try the xell image the light does glow every five seconds, but it stays lit for a while before going off (its stagnates rather than pulsates like when it glitched my ms dashboard).
Thanks for your help.
If you need more info, just ask.