Add Any Size External Hdd As The Internal Mem Unit Showing All Space A, Works for Stock Slims and RGH Slims (Use XBLive at own Risk) Options

[jery911]

does this work even if its not a 4gb slim?? ckuzz i have a non 4gb slim

thanks

[Antman1]

does this work even if its not a 4gb slim?? ckuzz i have a non 4gb slim

thanks

The only way to know if your KV has it disabled is to try it and plug a drive in and see if it is seen.

If you do this mod and you are using a 250GB console or Special Edition Console and you cannot see the internal memory in your storage area then you may have a KV on your console that has the Internal Memory unit disabled. If this is the case you will need to Reset Glitch Hack your console and use a keyvault from a 4gb slim to build your new RGH image so it will be enabled. However you cannot go on Xbox Live with RGH consoles.

This post has been edited by Antman1: May 7 2012, 09:47 PM

[Antman1]

if you are wondering what to do with your old 4GB IntMU I made a guide to turn it into a flash drive for PC or any xbox360. it is here: heavenlymodz.com

I wanted to follow up on this other guide I made to turn Internal 4GB MemUnit board into a flash drive.

I was testing this with my other memory unit that is a little newer than the one in my guide and it will not install a driver no matter what on the PC. however I can use it with USB to the memUnit port on the Slim Xbox360 without a problem. Here is the difference between the 2:

[psphackr]

To be honest, if you have a 250 GB console, then I don't see the point. Because 250 GB is plenty.

[marcus.miranda]

Hello guys,

Good day to you all!

I'm bringing this topic up again with a question: I have a Slim Gears 3 Limited Edition dual boot console without the 4Gb connector, so I'm assuming I have a KV that has the INTMU disabled (assuming because I have not tested it yet). If I have the INTMU disabled and use this MOD to add a 4Gb module, will it be safe to use this HW MOD online on my retail NAND or should I somehow cut the 4Gb power when switching to the retail NANDs?

If disabling is the choice, what should I use to disable it (switch, MOSFET, any other component)?

Thanks guys!