Rgh2 On Stinger Using Tx Files? Options

[sowa99]

Hi.
I'm wondering if xsfv from team xecuter would work on maximus stinger. Anyone know?

If someone has coolrunner and would be able to check where points on chip are connected, maybe we could figure it out to boot it on stinger

So, if somebody could trace coolrunner, I will measure my stinger

Regards

btw. I don't know why topic was moved here, it's about modchip research, not about onboard kernel

This post has been edited by sowa99: May 4 2012, 05:56 PM

[sowa99]

Okay, here we go with maximus stinger:


Stinger Pad ------- Xecuter pad ------ XILINX Stinger ------- Xilinx Xecuter

Slim/phat select ------ Switch ----- 13 ---------- x

D(I2CSDA)---F----25---x
E(i2cSCL)---E---24----x
C(STBYCLK)---B--35--x
P30(POST)--C--5--x
p40(CRESET)--D--13--x

There is PPL BYPASS too but it's not used in RGH2.
If someone will look at coolrunner please, check where C15 is connected!

Here is xc2c64a pinout:



This post has been edited by sowa99: May 4 2012, 07:29 PM

[iglitare]

c15 is betweeen CPU_RST and GND.
But only in Phat mode and only at a TX coolrunner.
Stinger has these 3 optional caps, as long as you don´t select them, you should have the same result like a TX coolrunner withoud c15.

BTW.
LED will not work, because i´ts wired at a different port on the stinger

[sowa99]

so if I will use rgh2 xsfv file from executer at stinger, this should work, right? So these chips are pin to pin compatible?

regards

This post has been edited by sowa99: May 5 2012, 06:19 PM