Jasper Wires Lenght/placing Options

[Br0k3R]

Hi


I've spend whole yesterday to glitch jasper(16mb) and i finally got it glitched today in the morning /~5s booting time, without any resistors and capacitors, clear matrix install/ (got xell booting, retrived cpu key, prepared nand image, flashed it and achieved booting to dash) but then i've moved the wires (only the placing of them) and now it doesnt boot anymore... i'm tired of this, spend whole day moving cables and waiting to boot, changing lenght of cables etc. As i'm sure its programmed ok /cause it was booting in the morning/ its only matter of wires. Can you give me some advices about where to place wires and what lenghts they should have?



best regards

[Br0k3R]

here is gallery


Zobacz całą galerię | Darmowe galerie Allegro


i've used nandpro 2.0e to read/flash images, xnandhealer 0.75 to remap one bad block, 360multibuilder 0.93 to prepare rgh image.

This post has been edited by Br0k3R: May 13 2012, 11:17 AM