Lt 3.0 And Benq/liteon Options

[zexbox]

Hello all,

I dont understand this?
I have no problems flashing the drives etc.. But is this right?

When I load the Ixtreme LT3.0+ Firmware on Jungleflasher the descriptions says LT 1.9

Cause I have problems loading after update but not old

[xboxdawg]

It will say 1.9 because they didn't change the description on it for 3.0. I remember that being the case when the 3.0came out and I just flashed one the other night and noticed that. However it still flashes fine. As long as you have the 3.0 firmware in the firmware folder then you're getting the right version.

This post has been edited by xboxdawg: May 30 2012, 07:23 PM

[n0fx]

It will say 1.9 because they didn't change the description on it for 3.0. I remember that being the case when the 3.0came out and I just flashed one the other night and noticed that. However it still flashes fine. As long as you have the 3.0 firmware in the firmware folder then you're getting the right version.

I'm trying to do the same thing but when I look at the target box, it picks the LTPlus-benq-v1.1bin and not the LTPlus-benq-v3.0.bin one. I'm running 0.1.92 beta build 304.

Is that right? I had the program auto select the firmware and I have firmware pack installed.