Ok, I'm in a bit of a jam here.
Last night I finally decided to flash my sammy ms28.
My onboard SATA detected my Xbox drive in JungleFlasher.
I proceeded to flash it with JungleFlasher by way of tutorials I've read and videos I've seen.
I'm running Windows 7 too by the way.
I used JungleFlasher, as stated earlier.
Found my drive. Clicked the MTK Flash 32 tab.
Clicked Intro/Device ID.
It found my Sammy and recognized it as the ms28.
I clicked Sammy Unlock.
I then clicked Read.
Saved my original firmware.
Then I clicked Write and it was writing the modified firmware to the drive and my power went out.
Now when I try to get it to recognize in JungleFlasher nothing comes up.
I try to get it to detect but then my PC freezes.
I have the right SATA port.
The right port in JungleFlasher.
Everything wired properly.
I just don't know how to get the original firmware back on to it now.
If I can get that I'll attempt to reflash it.
I'm not new to the modding world. I've hard modded my PS1 & PS2, softmodded my Wii and Xbox1.
But this one is driving me insane.
Can anybody please help?