Hdmi Tints Everything Red Options

[ifix]

xbox 360 slim halo reach edition
(are there different board revisions for the slim?)

Initially when plugged into first tv via hdmi, the dashboard was completely tinted red, however component works. Tried different hdmi cables and screen settings and same issue.
Tried two other tv's and there is no signal. Tried it on a computer monitor via hdmi and it works perfectly.

Does connecting to a computer monitor via hdmi go through a different route in the HANA/GPU/board?

Also, while plugged up to one of the tv's via component, everything working, I plug in the hdmi and the screen goes blank. So I believe it does recognize the hdmi being plugged in, but when i switch the tv to hdmi it says no signal.

I've also checked the port, and it seems fine. I'm going to reheat/resolder all the points for the video to ensure no cold joints.

Suggestions? Reflow HANA? Reflow CPU/GPU chip? Both? Do I need to remove the Y3B1 crystal near the HANA when reflowing? Can anyone refer me to a tut for reflowing HANA for times and temp (only reflowed gpu/cpu/ram's)?

I've seen this thread but there was no solution.
http://forums.xbox-scene.com/lofiversion/i...hp/t621832.html

ty

This post has been edited by ifix: Oct 5 2012, 07:54 PM